New roof systems for commercial buildings
Replacing a commercial roof is a capital project, and the decisions made at the start decide how long the new roof lasts. We look at what the building really needs, from drainage and insulation to energy code and scheduling, and install a system built for the next several decades.
No obligation · Response within 30 minutes
Every replacement starts with an assessment of the existing roof, including checks for trapped moisture. How wet the insulation is decides whether the old roof has to come off entirely or whether a new system can go over it where code allows.
From there we plan the system. TPO is the most common choice for Bay Area commercial buildings: a white, heat-welded membrane that reflects heat and helps meet cool-roof requirements. For a roof that is still sound, a coating may be a lower-cost alternative to replacement, and we will tell you if that fits.
A replacement is also the best time to fix what the old roof got wrong. That usually means drainage, insulation levels, curb heights and the flashing at parapets and edges. For our full range of commercial work, see commercial roofing.
The parts of a replacement that decide how long the new roof lasts.
Heat-welded white membranes over new insulation.
Old roofing and wet insulation removed and hauled away.
A new system over a dry existing roof where code allows.
Insulation cut to slope so water reaches the drains.
Equipment curbs and roof penetrations reflashed.
Wall flashing, coping and edge metal replaced.
Drains reset and scuppers relined with the new roof.
A coating system when the roof is still sound underneath.
A recover installs the new roof over the existing one, saving tear-off cost and disposal. It only works when the existing roof and insulation are dry and code allows another layer. Wet sections have to come out either way, because trapped water damages the deck under the new roof.
Many older commercial roofs pond after every rain because the deck was built nearly flat. Tapered insulation gives the new roof a built-in slope toward drains and scuppers, which is one of the most valuable upgrades a replacement can include.
California’s Title 24 energy code sets cool-roof requirements for many nonresidential low-slope reroofs, and can require added insulation in some cases. We confirm what applies to your building before the job is quoted, so there are no surprises at inspection.
Replacements are phased so each section is watertight before work stops for the day. We schedule deliveries, crane lifts and noisy work around tenants and business hours as much as the job allows.
Commercial reroofing generally requires a permit and inspections. We take care of the permit and coordinate inspections with the building’s schedule.
The dry season is the easiest time to replace a large roof. If a roof needs to last a little longer before a planned replacement, targeted repairs or a coating can bridge the gap. See commercial roof repair.
Call or send the form and tell us about the building and its roof.
We assess the roof, check for trapped moisture and review drainage and code requirements.
The old roof is removed or prepared, then the new system is installed in watertight phases.
A final walk of the roof with you, with permits closed out.
Not every aging commercial roof needs replacing now. If the roof is dry underneath and the problems are surface wear and weathered seams, a roof coating can add years for a fraction of the cost.
A commercial roof inspection with moisture checks shows how much of the roof is wet, which is the single biggest factor in the decision. Call (707) 470-7181 to schedule one.
It depends on the size of the roof, the system and how much wet insulation has to be removed. We give you a phased schedule with the estimate.
Sometimes. A recover is possible when the existing roof is dry and code allows another layer. Wet areas still have to be removed.
Title 24 sets cool-roof requirements for many nonresidential low-slope reroofs and can require added insulation in some cases. We confirm what applies before quoting.
For many Bay Area buildings, TPO is a strong choice: reflective, heat-welded and cost-effective. The right system depends on the building, its use and its budget.
Usually, yes. Work is phased so each section is watertight at the end of the day, and noisy work is scheduled around business hours where possible.
We replace commercial roofs from Suisun City across Solano County, Contra Costa County, Alameda County and Santa Clara County, including San Jose.